There is no other wildlife feeder like a Hurley-Byrd Covered Deer Feeder.
With its unique and beautiful design, setting up a deer feeding station in your
own backyard is simple. It will provide years of added wildlife feeding enjoyment
for you, your family and friends. Once established, daily visits from your deer
will become a highlight of each day throughout the year.

Like all our fine products, each Covered Deer Feeder is handcrafted with our
extremely robust, sturdy and long lasting Appalachain Mountain Lumber. Each
feeder is assembled with ceramic coated screws and the protected with an
application of our proprietary penetrating oil finish, which is not just wiped on lightly.
Each component is completely submerged in a large vat filled with finish then allowed
to soak before a final hand rubbing to further work it into the wood. This produces a
  Free Standing Covered Deer Feeder 
Are they easy to assemble and install?

All Hurley-Byrd Covered Deer Feeders are simple to assemble. A battery powered drill or
a screwdriver handle that accepts interchangeable bits is required as we use ultra high quality torx head screws
throughout our feeders. For assembling the roof, we provide the needed screws and a matching bit for installation.
The remainder of the feeder is assembled using carriage bolts, washers and wing nuts. The carriage bolts
and wing nuts allow for easy and quick assembly plus allow you to disassemble the feeder as desired.


Free Standing Covered
Deer Feeders (FSCDF)

We utilize our Extra Large 35" or Ultra Large 47"
trough holding 25 or 35 pounds of feed in each feeder.
The trough is set at a perfect 24" height so your
deer, even the babies, feed comfortably.

The new roof is 21" wide, 47" or 59" in length and
its height above the trough adjusts from 16", 19"
or 21" to help protect the trough's contents from rain
and falling/melting snows. The roof and its supporting
legs can easily be removed and stored when desired.

All this stands on 34” feet with strong
diagonal supports. The new feet have gained
nearly 50% in length over previous models and no
longer requires ground staking. This makes
moving the feeder around your home or
putting it up for storage far simpler.
Free Standing Covered Deer Feeders provide
you with the ability to simply move the feeder from one
location to another or as a feeder which can be stored
away completely when desired.

A Hurley Byrd Free Standing Covered Deer Feeder
is easy to set up, simple to move and can quickly
be put away for off season storage.
feeder like no other and when you set up a new Hurley Byrd Deer Feeder you add class,
beauty and elegance to your home.

You will now enjoy quick success feeding your
furry (and some feathered) friends with Shelled
Corn, Deer Chow, Apples, Beets, etc....
For more feed and feeding information,
click here to read our article
"Feeding Deer Safely and Successfully".
View an Extremely
Successful Deer
Feeding Station.








30+ photos, including world class Mule Deer and an Elk the
size of a house..........
...............well almost.

8000' in the
Rocky Mountains of
Colorado.

A must see photo set.
Click the Photo or
Click Here










Baby Fawn Resting.
2nd Generation CDF. Intro - 2008

A big Thank You to
L.B. of Longmeadow, MA for
this outstanding photo of a
Hurley-Byrd 2nd Generation
Covered Deer Feeder hard at
work during New England's
heavy snows.

This is a perfect example of a CDF doing what it does best.
Ordering and Delivery Time

Delivery Time:
When CDFs are in stock, they ship the next day. When we are building them, allow 3 business
days before shipping. Periodically, we are scheduled to perform a build in 1 to 3 business days and will
require a bit more time to reach the schedule date and then build. Maximum wait period, 6 business days.

How to Order:
Using the dropdown menu below, chose your desired size(s). Either Extra Large or Ultra Large.
If you wish to have a mix of sizes, please do. Your cart will automatically generate the correct discount.

Shipping Rates and Transit Times.
An Extra Large CDF weighs 52 pounds in its box, an Ultra Large 62 pounds.
We craft stout feeders and the shipping rates will reflect this. The rate you receive is correct and accurate.
Transit times can be found here.

Sizes: Each CDF Stands 48" in Height. Feed Trough Height is 24"
(EL) Extra Large, 25 Lbs Capacity, 35" Trough and 47" Roof. Weight less feed is approximately: 48lbs
(UL) Ultra Large, 35 Lbs Capacity, 47" Trough and 59" Roof. Weight less feed is approximately: 58lbs

What Makes the New 5th Generation CDF......... Well, NEW?
The 4th Generation CDFs of 2013 received upgrades from our years of building this feeder. Our goal was to
produce a more elegant design/appearance, better feed protection and do so without cost increases.
The New 5th Gen takes this great design one step further with our new Preserved Wood Lumber. (PWL)
The biggest design improvement was in the roof.
The 1st-3rd Gen.CDFs had a roof approximately 16" wide.
This worked but did not allow us to raise the roof to
trough clearance any further than 17".

We upgraded our 3 segment roof to an interlocked 4 segment, 22" assembly shown below in cedar having full tongue and groove interconnects, even at the angled peak!

Once assembled, there will be no water leakage,
even during winter snow melt. Plus the new roof
with its simpler lines is far more aesthetically pleasing.


Increased Trough to Roof Clearance

Having a wider roof allows an increase
in the trough to roof clearance.
The old 17" maximum clearance did not
allow for mature bucks to get into the feeder.
More specifically, getting out of the feeder.

With its 22 inches of maximum clearance, your
deer will feel safer and are less likely to get caught
up in the roof, subsequently lessening the
likelihood of harming your wildlife.

As before, you retain the ability to adjust the
roof as your feeding needs change. During the time of
year your deer are antlerless, lower the roof (16".)
In fall, raise or remove.
A Wider Stance
All old CDFs used a 24" foot. We felt this
was too short and needed to extend the stance.
The new foot/leg/diagonal design, we gained nearly
50% in width and easier assembly. No more ground
spiking allows quicker, easier movement and storage.
In Summary, It's Our Best Yet.
There are lots of little changes, new improvements, etc.
Simply be assured when you use a Hurley-Byrd Covered Deer Feeder, you are installing the very best.

Crafted in FFY for the 2019 Season
FFY is our Forest to Finish to You prgram. in which
we produce our very own lumber. Yes, we actually
harvest the tree, produce the lumber and then
craft your feeders.  All the details are here FFY
Size Really Does Matter?

As for choosing a size....
Time has proven Customer
purchases are nearly 50/50
between the Extra Large and
Ultra Large with the Ultra Large
slightly nudging into the lead.

With the price difference
being relatively small, we
highly recommend the larger.
Since you can always put 25
pounds of feed in a 35 pound
capacity feeder but never the
other way around.

Aesthetically Speaking

The aspect ratio of
height to length is far more appealing with the Ultra Large's
more rectangular appearance
being 48" Tall x 60" Long
compared to the EL's
48" x 48" square stature.
Just our 2 cents.


HB's Current CDFs are
being handcrafted in:

Red Oak Leg Sets
w/ Poplar Troughs and Roofs

Brutally STRONG, dark reddish brown
Oak leg sets with Poplar lumber troughs
and roofs with its beautiful creamy
whites, grassy greens
and earthy tans.

You Will Positively LOVE 'Em!
Order Your Very Own Today

Free Standing
Covered Deer Feeder
Assembly Instructions.
in a PDF File
4th Gen. EL CDF shown here crafted in cedar.
5th Gen feeders - Same design, new lumber. All CDFs now come in FFY.
Above - 5th Gen. Ex Lg CDFs in PWL.

Below - 2015 Ultra Large
Hurley Byrd CDF Pricing:
ELCDF: Extra Large Free Standing CDF: $249.95
ULCDF: Ultra Large Free Standing CDF: $299.95












.

Add a new deer feeder to your home and yard today.

The Rut will be here soon..... attracting the Doe deer and their fawns now
will hold them into the Rutting Season................. which in turn
brings with it the best chance of having the BIGGEST bucks visit too!!!!
Quantity Discount Pricing:










Orders of 2: EL: $224.96 Each   -   UL: $269.96 Each
Orders of 3: EL: $199.96 Each   -   UL: $239.96 Each

The 2nd and 3rd Feeders will receive FREE SHIPPING
Free Standing CDF: Size and Qty Discounts
Hurley Byrd Covered Deer Feeder - On Sale - Save 25%

462 Williams Crossroads Way
Fairmont, West Virginia 26554
Phone: 877-363-0199 M-F 10-8 EST
Shop by:
Feeder Style















Installation










Miscellaneous





View Cart
Hurley Byrd's Festival of Feeders
Pick Your Exact Feeder Exclusively on eBay


Pre Holiday Rush Sale
Order Your Holiday
Deer Feeders Now
Save 25% - See Details Below
On Sale TODAY..... Shopping Cart
Automatically gives you a
25% discount. No Codes, No Min/Max
Order Now!
------------  $187.46
------------  $224.96

Hurley Byrd Does it Differently, Very Differently:
We handcraft each and every feeder we sell. Starting with our own designs, producing OUR OWN Lumbers and assembling your feeders with
real screws throughout. We then protect each feeder with a beautiful penetrating oil finish so they last for many years. We take pride in our service, too.
From the moment you first interact with us, whether on our website or on the phone, to the delivery of your feeders and gifts and everything in between.
We want to make owning and gift giving easy for you. So whether it's a simple thank you, a unique deer feeder gift a whole
feeding station for you and your family, choose Hurley-Byrd and see the difference our feeders really make.


All Rights within this website and its related
products are Copyrighted and Reserved by:
Hurley Byrd Wildlife Feeders
462 Williams Crossroads Way
Fairmont, West Virginia 26554
Telephone: 877-363-0199
© 2002 - 2019
Hurley-Byrd Home Page  Contact Us  Privacy Policy